Power On/Off; Cleaning Mode Selection - Home Hm-Rv-A350B Bedienungsanleitung

3. Prevent the vacuum from attempting to enter spaces with less than 70 mm clearance;
it might get stuck. If necessary, block off such spaces by setting a suitable ground-
standing object before them.
4. The vacuum is not designed for cleaning wet areas. Do not expose it to water or
moisture.
5. The vacuum can drive over obstacles up to 16 mm high. Remove taller obstacles if
necessary.
6. The vacuum is equipped with surface sensors, designed to keep it from falling off stairs
etc. These sensors' readings can be fouled by dirt on the sensor eye, dark or reflective
floor materials, and other adverse conditions. We thus recommend blocking off areas
where the vacuum might fall off a step or ledge with suitable obstacles.
Power On / Off
1. Set down the vacuum in the room to be cleaned. Make sure it has a full charge.
2. Set the main switch to the I (on) position.
3. Turn the appliance on by pressing
vacuum will turn on in automatic cleaning mode.
4. When the vacuum is operating, the
5. Once the space has been cleaned or if you need to stop cleaning, press
vacuum or
6. To power down completely, set the main switch to 0 (off).

Cleaning Mode Selection

The cleaning mode can only be changed using the remote control.
1. Edge Cleaning Mode
The edge cleaning mode allows for effective cleaning along walls, furniture edges, etc.
The vacuum will start out same as in automatic mode, but will slow down and then keep
hugging a wall or edge as soon as it detects one. The slower speed allows better cleaning
of such places. Once the vacuum detects an end to the edge it has been following, it will
return to automatic cleaning mode.
To turn on edge cleaning mode, press
2. Thorough Cleaning Mode
Thorough mode improves the thoroughness of cleaning in a bordered space. Once
activated, the vacuum will move in a squared spiral, cleaning the space from the center
outward. This approach allows for maximum coverage and effectiveness.
To turn on thorough cleaning mode, press
3. Automatic Cleaning Mode
In automatic mode, the vacuum combines various pathfinding algorithms to efficiently
cover the entire floor space.
Automatic mode is the default mode the vacuum starts in when powered on.
To turn on automatic cleaning mode, press
10
on the remote. The vacuum will stop cleaning and go to standby mode.
on the vacuum itself or
button on its body will glow blue.
on the remote.
on the remote.
on the remote.
USE
on the remote. The
on the