Cleaning And Maintenance - Home Hm-Rv-A350B Bedienungsanleitung

Note:
In some situations, the vacuum will switch to a different mode on its own, usually in
reaction to obstacles or other features of the room. This is normal behavior intended to
improve the efficiency of the vacuum's cleaning routine.
Wet Cleaning Attachment
This rear-mounted attachment allows the appliance to also wipe the floor it has just
vacuumed.
1. Rinse the provided rag in warm water; use a modest amount of a detergent suitable
for the flooring type to be cleaned. Wring out the rag and mount it onto the wet
cleaning attachment's frame.
2. Turn the vacuum upside down an click the attachment into place in its sockets.
3. Turn the vacuum right side up again and power on.
Note:
In larger and / or dirtier rooms, you will likely need to remove, rinse, wring, and remount
the rag at some point. When removing the rag, always first power down the vacuum and
set the main power switch to the 0 (off) position.
Before any cleaning or maintenance, first power off the appliance and unplug the adapter
from the wall socket.
For best cleaning efficiency and service life, the vacuum should be cleaned after each use.
Warning:
Never immerse the appliance or adapter in water or other liquids.
Never clean any part of the appliance with plastic or metal scrapers, harsh cleaners,
chemicals, hydrocarbon cleaners, solvents, or similar substances. The surface finish could
be seriously damaged.
Cleaning the Rotary Brushes
1. Unmount the brushes from the appliance frame and clean them.
2. Heavily soiled brushes should be rinsed in running water, then set out to dry. If a brush
has bent bristles, straighten them by immersing the brush in warm water.
3. Only remount the brushes on the vacuum once they are completely dry.
4. Damaged rotary brushes should be replaced.
Cleaning the Dustbin and Filter Assembly
The dustbin needs to be emptied as necessary, which may occur in mid-cleaning. Make
sure the device is powered off, with the main power switch in the 0 (off) position.
1. Open the cover plate.
2. Remove the dustbin and check that the suction aperture is free of blockage. Clean
both as required.
3. Remove the HEPA filter frame.
4. Open the dustbin lid and carefully remove the bulk filter.
5. Empty the dustbin in the trash. From a sanitation perspective, it is best to empty the
dustbin outside living areas.

CLEANING AND MAINTENANCE

11