Cleaning And Maintenance - Siguro SGR-WC-F121B Bersetzung Der Original Bedienungsanleitung

The interior lighting will automatically turn off after 10 minutes of inactivity.
Change of temperature units
Press and hold the light/temperature unit change button to change from °C to °F. To
change the units back to °C, press and hold the light/change temperature unit button.
Display stability
°C units: When the temperature measured by the temperature probe is within ± 1 °C of
the set temperature, the display will show the set temperature value.
°F units: When the temperature measured by the temperature probe is within ± 2°F of
the set temperature, the display shows the set temperature value.
Defrosting
Defrosting occurs automatically by interrupting the operation of the thermoelectric
cooler.
• If the semiconductor cooling system is in continuous operation for 24 hours, the
operation of the thermocouple is interrupted for 10 minutes.
Power outage
If the power supply is interrupted, the settings will be saved in the thermoelectric
cooler's memory, and after the power is restored, the cabinet will start with the original
settings.
Recommendations for proper wine storage
The thermoelectric cooler is intended exclusively for storing wine in bottles. It is not
intended for storing food, frozen products, medications, etc.
The recommended set temperature to ensure maximum performance is 17 °C.
The location of the shelves from the factory represents the most efficient use and
energy consumption when using the thermoelectric cooler.
If the ambient temperature is 25°C and the thermoelectric cooler is empty, it will take
about 30 minutes for the temperature to rise from 5°C to 12°C. However, under the
same conditions, it will take about an hour for the temperature to drop from 12°C to
5°C. The smaller the temperature range, the faster you reach the set temperature.
The recommended set temperature of the thermoelectric cooler is 17 °C. In this case,
the power consumption is 0.23 kWh/24 hours. If the set temperature is lower, the en-
ergy consumption will be lower. If the set temperature is higher, the energy consump-
tion will be higher.

CLEANING AND MAINTENANCE

Before cleaning or any maintenance, always disconnect the thermoelectric cooler
from the mains socket and let it cool down.
Warning:
Never immerse the appliance, the power cable and plug in water or any
other liquid.
Do not use plastic or metal scrapers, harsh cleaners, chemicals, petrol, solvents or
other similar substances to clean any parts of the appliance. The surface finish could
be seriously damaged.
Wipe the outer surface of the thermoelectric cooler and shelves with a soft sponge
EN - 9
EN