Troubleshooting - Siguro SGR-WC-F121B Bersetzung Der Original Bedienungsanleitung

EN
slightly moistened in warm water. Wipe with dry dish towel.
Check the door seal and wipe it with a soft sponge.
Storage
If you are not going to use the thermoelectric cooler, clean it according to the instruc-
tions above. Leave the door open. Store in a dry and well-ventilated place out of the
reach of children or pets. Secure the thermoelectric cooler so that it is impossible to
climb into it and close the door. If the thermoelectric cooler is equipped with a lock,
remove it or take measures so that the lock cannot be activated.

TROUBLESHOOTING

Problem
The thermoelectric cooler
does not work.
The thermoelectric cooler
is too noisy.
The thermoelectric cooler
does not cool sufficiently.
The display shows the error
message EE.
The display shows the error
message LL.
Cause
The plug is not properly
plugged into the socket.
The voltage in the socket
is too low/the socket is not
under voltage.
The thermoelectric cooler
is not level/it is placed on
an uneven surface.
The thermoelectric cooler
touches another object or
wall.
You have set an incorrect
temperature.
The thermoelectric cooler
door is not closed properly/
you open it often/open it
for a long time.
The thermoelectric cooler
is placed in direct sunlight/
near heat sources.
Poor heat dissipation.
The temperature probe is
shorted out or disconnect-
ed. thermoelectric cooler
operation stopped.
The temperature probe
recorded an ambient
temperature below 0 °C.
The thermoelectric cooler
operation has stopped.
EN - 10
Solution
Insert the plug into the
socket.
Have the voltage in your
socket checked. Contact a
qualified electrician.
Adjust the feet of the ther-
moelectric cooler/move the
thermoelectric cooler an
even surface.
Move the item or thermo-
electric cooler and make
sure there is enough free
space around it.
Adjust the temperature
setting.
Check the door seal. Open
the door only for as long as
necessary.
Move the thermoelectric
cooler to a place where it
will not be exposed to di-
rect sunlight/heat source.
Check that there is suffi-
cient air circulation.
Contact an authorized
service centre.
The ambient temperature
is too low, move the ther-
moelectric cooler.