Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
USE
Before first use
Remove the appliance and its accessories from the packaging. Check the appliance
for damage.
Wipe the exterior surface of the appliance and shelves with a soft sponge slightly
moistened in warm water. Wipe with dry dish towel.
Installation
•
This appliance is designed to be free-standing. It is not intended as a built-in
appliance or built into a cabinet.
•
Install the thermoelectric cooler on a solid, level and stable surface to support its
weight when filled to maximum.
•
Level the thermoelectric cooler by unscrewing or screwing the feet.
•
To ensure sufficient air circulation, leave a free space of at least 10 cm around the
appliance.
•
Install the thermoelectric cooler in a place where it will not be exposed to direct
sunlight, heat sources (stove, heater, radiator, etc.). Direct sunlight can damage the
finish and heat sources can increase electricity consumption. Installation in a room
that is too cold can negatively affect the operation of the thermoelectric cooler.
•
Do not install the thermoelectric cooler in a very humid or dusty environment, in a
room where explosive or flammable substances are stored/used, in a room where it
might freeze, etc.
•
Connect the plug of the power cable only to a properly grounded mains socket. Do
not make any modifications to the electrical wiring. We recommend connecting
the thermoelectric cooler to a separate electrical circuit.
•
After plugging in, leave the thermoelectric cooler running empty for 2 to 3 hours to
allow the interior space to cool down properly.
Switching On/Off
After connecting the plug to the mains socket, the thermoelectric cooler will automat-
ically turn on and start cooling.
If you need to turn off the thermoelectric cooler, remove the plug from the mains
socket.
Do not switch the thermoelectric cooler on and off in very short time intervals to avoid
damaging the compressor.
Setting the temperature
The temperature setting buttons are used to adjust the temperature. Each press in-
creases/decreases the value on the display by 1°.
Temperature setting range: 10 to 18 °C
Lock/Unlock the control panel
The thermoelectric cooler is equipped with the function of automatically locking the
control panel after 20 seconds of inactivity.
Press the lock button to unlock the control panel.
Interior lighting
Activate the interior lighting by briefly pressing the lighting/change temperature units
button. Repeated brief press will turn off the light.
EN - 8
Werbung
Inhaltsverzeichnis
Fehlerbehebung
