Denver MT-779 Bedienungsanleitung Seite 3

CONNECT DVD PLAYER TO OTHER
APPLIANCES
It is recommended you connect the player to a multi-system
TV.
Ensure that this player and other appliances (TV set and
amplifier) that will be connected to the player are set to OFF
mode and that the AC/DC adapter is disconnected from the
wall outlet.
Avoid blocking ventilation holes of the connected appliances
and make sure air around there can circulate freely.
Read carefully and follow the instructions before connecting
other appliances.
Observe the color coding when connecting audio and video
cables, for instance connect yellow plug to the yellow jack,
the red plug to the red jack and so on. If the RCA adapter is
supplied only, the audio/video RCA cable is required. Plug
one end of the RCA adapter to the unit. Then connect the
audio/video RCA cable to the RCA adapter and the
television.
Note: The AV cable with 3.5mm diameter and 1.5cm length
plug is not applied to the product.
S-VIDEO
AUDIO R AUDIO L VIDEO IN
AV AUDIO/VIDEO INPUT
A/V cable
CHARGE THE BUILT-IN BATTERY
The player is with a rechargeable lithium battery. Before
using the battery, please make sure it is charged. If not,
charge it first. Slide the power switch to OFF position and
then connect one end of the supplied adapter to the wall
outlet and the other end to the unit for charging the built-in
battery.
Note:
1. The battery only could be charged at powering off mode.
2. If the unit is not in use for a prolonged period of time, it is
recommendable to charge the built-in battery each three
months.
CONNECTING TO A CAR ADAPTOR
The car power adaptor is designed for use with vehicles that
have a 12V, negative ground electrical system.
WARNING:
Disconnect the car power adaptor when not in use. Not in
use in 24V vehicles.
CAUTIONS:
Use the unit only with the recommended car power
adaptor, use with other car power adaptor might damage
the unit.
The recommended car power adaptor is for use with this
unit only. Do not use it with other equipment.
YUV INPUT
TV SET
To the cigarette lighter socket
In the interests of road traffic safety, do not operate the
unit or view video software while driving a vehicle.
Make sure the unit is fastened securely to prevent from
moving outside of the vehicle in an accident
When the inside of the cigarette lighter socket is dirty with
ashes or dust, the plug section may become hot due to
poor contact. Be sure to clean the cigarette lighter socket
before use.
After use, disconnect the car power adaptor from both the
unit and cigarette lighter socket.
FUSE REPLACEMENT
FUSE
POSITIVE(+) CAP
NOTE: Don't throw out the positive(+) cap when replace the
fuse.
OPERATIONS
PREPARATION
Power on the TV set and select video input mode.
Power on the audio system which is connected to the player.
GET STARTED
1. Slide POWER ON/OFF switch to turn on the player.
2. Press disc cover Open button to open the disc tray.
3. Place a disc onto the disc tray.
4. Close the disc tray by hand and the playback starts
automatically.
5. When a menu screen appears on the TV, press the
navigation buttons or press the numeric buttons to select
a preferred track number, then press OK button to start
playback.
ADJUST THE VOLUME
Press the VOLUME +/- buttons to increase or reduce the
volume.
MUTE
While the power is on, the audio output of the main unit is to
be switch off by pressing the button. Press it again to
resume sound output.
SKIP AHEAD OR BACK
Press PREV button during play to skip previous chapter
(DVD) or a track (CD), Press NEXT button during play to
skip next chapter (DVD) or a track (CD).
BRIGHTNESS AND COLOR ADJUSTMENT
During playback, press SCREEN ON/OFF&BRI/COL button
repeatedly to adjust brightness and color respectively via
navigation right/left button. Press and hold this button to turn
on/off the screen.
RAPID ADVANCE/REVERSE
During playback, press and hold F_FWD button or F_BWD
button to scan the disc forward or backward at X2, X4, X8,
X20 of normal speed.
Press PLAY/PAUSE button to resume normal play.
STOP PLAYBACK
Press STOP button during playback to stop playback; the
player activates its resume function when STOP is pressed
in STOP mode; press PLAY/PAUSE button again, playback
resumes at the point it stopped previously; open the disc tray
or press the STOP button one more time to clear the resume
function.
2