Maintenance; Maintenance Schedule; To Clean The Product - Husqvarna PW 130 Bedienungsanweisung

Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of

Maintenance schedule

Maintenance

Do a general inspection. Refer to
Clean the product. Refer to
Clean the spray lance and the nozzles. Refer to
on page 18 .
Clean the water filter. Replace the water filter if it is damaged. Refer to
filter on page 19 .
Lubricate the O-rings on the couplings. Refer to
on page 19 .
To do a general inspection
WARNING:
off (0) position and disconnect the power
plug from the power source before you do
maintenance on the product.
CAUTION:
the water source and make sure that all
parts are dry before you do maintenance on
the product.
• Make sure that the nuts and the screws on the
product are tightened.
• Make sure that the cables on the product are not in a
position where they can be damaged.
• Examine the high-pressure hose for wear and
damage.
WARNING:
product if the high-pressure hose is worn
or damaged.

To clean the product

WARNING:
off (0) position and disconnect the power
18
Maintenance
Before you do
To do a general inspection on page 18 .
To clean the product on page 18 .
To clean the spray lance and the nozzles
To lubricate the O-rings on the couplings
Put the power switch in the
Disconnect the product from
Do not operate the
Put the power switch in the
professional repairs and servicing. If your dealer is not
a service agent, speak to them for information about the
nearest service agent.
For more detailed information, refer to
www.husqvarna.com.
To clean the water
plug from the power source before you do
maintenance on the product.
CAUTION:
the water source and make sure that all
parts are dry before you do maintenance on
the product.
• Clean all external parts with a dry cloth.
• Do not use a high-pressure washer to clean the
product.
• Keep the air inlets clean to make sure that the
product always has sufficiently cool temperature.
To clean the spray lance and the nozzles
WARNING:
off (0) position and disconnect the power
plug from the power source before you do
maintenance on the product.
CAUTION:
the water source and make sure that all
parts are dry before you do maintenance on
the product.
1. If a nozzle is installed on the spray lance, remove it
from the spray lance. Refer to
a nozzle on page 15 .
Before use After use
X
X
X
X
X
Disconnect the product from
Put the power switch in the
Disconnect the product from
To install and remove
1839 - 006 - 21.10.2022