Operation; Troubleshooting; Maintenance; Warranty - Fellowes MS-460Cs Anleitung

OPERATION

Disconnect power switch must be in ON (I) position to operate shredder. Insert waste bag (Fellowes #36052) for easy disposal.
Continuous operation:
10-12-minute maximum
Set to ( )
and plug in
NOTE: Shredder runs briefly after
each pass to clear entry.
Continuous operation beyond
10-12-minutes will trigger a cool
down period to resume operation.

TROUBLESHOOTING

Paper jam: Set to Off ( ) and empty bin. Replace bin and follow any or all of the below procedures.
Press and hold
Alternate slowly back and forth
Reverse ( )
ATTENTION: If the SafeSense light remains on, you must engage the
®
(See SafeSense instructions below.)
®
SafeSense paper jam: If the SafeSense
®
to think the shredder has jammed when it has not, use the Override Switch to deactivate the SafeSense
feature and clear the paper. Warning – when switch is in override position, the SafeSense
the SafeSense feature will NOT function. Once the paper is cleared, reset the SafeSense
®

MAINTENANCE

Run regularly in reverse for
one minute
Oil when bin is full, or
immediately, if:
• Capacity decreases
• Motor sounds different, or
Shredder stops running

WARRANTY

Limited Warranty: Fellowes, Inc. ("Fellowes") warrants the parts of the machine to be free of defects in
material and workmanship and provides service and support for 2 years from the date of purchase by the
original consumer. Fellowes warrants the cutting blades of the machine to be free from defects in material
and workmanship for 7 years from the date of purchase by the original consumer. If any part is found to be
defective during the warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes'
option and expense, of the defective part. This warranty does not apply in cases of abuse, mishandling, failure
to comply with product usage standards, shredder operation using an improper power supply (other than listed
on the label), or unauthorized repair. Fellowes reserves the right to charge the consumers for any additional
PAPER
Press Auto-On ( )
CARD/CD/3.5 DISK
Press Auto-On ( )
Set to Off ( )
and unplug
Override Switch in order to perform steps above. Once the jam is cleared, reset the SafeSense
feature activates (SafeSense
® ®
Follow oiling procedure below and repeat twice.
*Apply oil Press Forward
across entry
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
Feed into paper entry
and release
Hold card/CD/
3.5 disk at edge
Gently pull uncut Press and hold
paper from paper Reverse ( )
entry. Plug in.
light remains on) to cause the user
®
light will flash and
®
feature.
®
Shred one sheet
costs incurred by Fellowes to provide parts or services outside of the country where the shredder is initially sold
by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH
ABOVE. In no event shall Fellowes be liable for any consequential or incidental damages attributable to this
product. This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are
valid worldwide, except where different limitations, restrictions, or conditions may be required by local law. For
more details or to obtain service under this warranty, please contact us or your dealer.
Set to Off ( )
and unplug
Feed into card/CD/3.5
disk entry and release
Indicator lights:
Yellow - SafeSense active
®
10
Yellow flashing - SafeSense
®
not active
Make sure bin is pushed in
Wait for motor to cool down
feature.
®
Sensor light illuminated–paper jammed
10
10
SafeSense override switch
®
10
Active Not active
Press and hold Reverse ( )
2-3 seconds
3