Important Notice; General Data - Hitachi YUTAKI M ATW-YMM-02 Installations- Und Betriebshandbuch

IMPORTANT NOTICE

3 IMPORTANT NOTICE
• The supplementary information about the purchased
products is available through the QR printed in the front
cover. In case that no access to the website or files are not
readable, please contact your Hitachi dealer or distributor.
• PLEASE READ THE MANUAL AND DOWNLOADED
FILES THROUGH THE QR CAREFULLY BEFORE
STARTING TO WORK ON THE INSTALLATION. Failure to
observe the instructions for installation, use and operation
described in this documentation may result in operating
failure including potentially serious faults, or even the
destruction of the air conditioning system.
• Commissioning, Servicing and Main safety devices are
explained in YUTAKI M technical documentation.
• Verify, in accordance with the manuals which appear in
the unit, that all the information required for the correct
installation of the system is included. If this is not the case,
contact your distributor.
4 FACTORY-SUPPLIED UNIT COMPONENTS
Accessory Image
Unit
controller
wire
Screws
LCD unit
controller

5 GENERAL DATA

Item
Power supply
Max Input
Dimensions (HxWxD)
Weight (Gross/Net)
Mounting conditions
2 PMML0603 rev.0 - 02/2023 - 1000014074
Qty. Purpose
Wire for the connection
between YUTAKI M Remote
1
control box with the Unit
controller (PC-ARFH2E).
These two screws are to
assembly the Unit controller to
2
the Remote control box front
cover.
1 PC-ARFH2E
Units Description
V 1~230V / 50Hz
kW 3.2
mm 490 x 360 x 100
Kg 6.15/5.45
- Indoor
• Hitachi pursues a policy of continuous improvement in
product design and performance. The right is therefore
reserved to vary specifications without notice.
• Hitachi cannot anticipate every possible circumstance that
might involve a potential hazard.
• No part of this manual may be reproduced without written
permission.
• If you have any questions, contact your service contractor of
Hitachi.
• Signal words (NOTE, DANGER and CAUTION) are used
to identify levels of hazard seriousness. Definitions for
identifying hazard levels are provided in initial pages of this
document.
• The operation modes of these units are controlled by the unit
controller.
• This manual should be considered as a permanent part of
the purchased product. It gives a common description and
information of the product which you operate as well as for
other equipment.
Accessory Image
Caps
Installation
and
Operation
Manual
?
N O T E
• The previous accessories are supplied inside the unit.
• If some of these accessories are not packed with the unit or any
damage to the unit is detected, please contact your dealer.
Qty. Purpose
To be placed at the front cover
to fill the holes when unit
2 + 1
controller not attached to the
Remote control box
The latest revision of the
1 Remote control box technical
documentation