Touch Control; Led Indicator - Urbanears Boo Bedienungsanleitung

EN

HOW TO PAIR
01. Put both earbuds in the case and keep the lid open.
02. Press and hold the button on the case for 2 seconds. Release it when the LED
indicator blinks blue.
03. Select Urbanears Boo from your device's Bluetooth menu to pair. Done!


TOUCH CONTROL

The touch control surfaces are located on the left and right earbud.
— Tap once to play/pause or accept/end calls.
— Tap twice to skip forward or reject calls.
— Taps three times skip backwards.

CHARGING
Place the earbuds in the charging case and close the lid to charge the earbuds and
turn them off.
Connect a charger with a USB-C charging cable to charge the case (not included).
If left unused, the earbuds will go into standby in order to save power. Just tap both
earbuds to wake them up again.


LED INDICATOR

Blue light is ready for Bluetooth pairing. Red (low) to green (full) is for the case
battery status.
CLEANING
Earbuds come in close contact with your skin often and sometimes for long
periods of time. This will over time cause build-up of dirt and grease that can affect
performance and may cause skin irritation. Clean your earbuds regularly to keep
them fresh and make them last longer.
Unplug any cables before cleaning the case. Make sure everything is completely
dry before using the earbuds, putting the earbuds back in the case, or plugging in a
USB charger.
Use a disinfectant wipe or a lint-free cloth, slightly damp with 70% isopropyl alcohol
or 75% ethyl alcohol to gently clean the exterior surfaces of the earbuds and the
case. Avoid getting moisture in any openings or in the speaker mesh. Carefully clean
those areas with a dry and soft brush, or a cotton swab.
— Do not use any sharp objects.
— Do not use compressed air.
— Do not use products containing bleach or hydrogen peroxide.
— Do not submerge the earbuds in any cleaning agents.
TROUBLESHOOTING
EARBUDS DO NOT BEHAVE AS EXPECTED
If your earbuds behave erratically or are unresponsive, follow the instructions
below.
01. Put both earbuds in the case and close the lid to restart the earbuds.
If the problem persists, perform a factory reset.
Note: This will delete all user settings and the earbuds will need to be paired again.
01. Put both earbuds in the case and keep the lid open.
02. Press the button on the case and release it when the LED turns purple.
03. Remove Urbanears Boo from your device's Bluetooth menu before pairing
again.
LEFT OR RIGHT EARBUD DOES NOT PAIR
If you can only connect to either the left or the right earbud but not both, follow the
instructions below.
01. Make sure that both earbuds are charged.
02. Remove Urbanears Boo from your device's Bluetooth menu.
03. Put both earbuds in the case and keep the lid open.
04. Triple press the button on the case and the LED indicator blinks green.
05. The LED blinks blue when the earbuds are coupled and are ready for pairing.