Add An Additional Remote; Manual Override; Activate / Deactivate The Kickback Function In Case Of Obstacle; Change Operation In Case Of Obstacle - SmartSun 2984836 Benutzerhandbuch

8.2 REMOVE CONTROL-ENGINE SYNCHRONISATION
To synchronize the control with the motor, the following steps must be followed:
• Disconnect the motor from the mains and wait more than 10 seconds to reconnect. The
motor will beep.
• Press the "STOP" button for 2 seconds.
• The motor will make 2 movements and 3 beeps.
• Settings OK.
• If when we press the "DOWN" button the awning opens, it is a good configurator. If it closes,
follow the instructions:
• Press the "UP" and "DOWN" button at the same time for 2 seconds.
• The motor will make a movement. The direction of rotation has been changed.

8.3 ADD AN ADDITIONAL REMOTE

This option allows the engine to be controlled by several controls.
Method 1
• Without disconnecting the motor.
• Press the "P2" button on the already programmed remote for 1 second. The motor will beep
and move.
• Press the "P2" button on the already programmed remote for 1 second. The motor will beep
and move.
• Press the "P2" button on the new remote to be added 1 time. The motor will make 2
movements and 3 beeps.
• Settings OK.
Method 2
• Without disconnecting the motor.
• Press the "P2" button on the already programmed remote for 1 second. The motor will beep
and move.
• Press the "P2" button on the already programmed remote for 1 second. The motor will beep
and move.
• Press the "STOP" button on the new remote to be added for 2 seconds. The motor will make
2 movements and 3 beeps.
• Settings OK.
56
8.4 DELETE CONTROL-MOTOR SYNCHRONIZATION
This option allows us to eliminate the synchronization of the control with the motor.
• To delete the new remote, follow method 1 of "Adding an additional remote".
• To delete all controls:
• Press the "P2" button on the already programmed remote for 1 second, wait for the motor
to move and beep. Press the "STOP" button for 1 second and wait for the motor to move and
beep.
• Press the "P2" button on the remote control for 1 second, the motor will make 2 movements
and 3 beeps.
• Settings OK.

8.5 MANUAL OVERRIDE

This awning includes an auxiliary ring to actuate the awning manually in case of emergency.
(drawing) change to the drawing of the screw ring.
8.6 ACTIVATE / DEACTIVATE THE KICKBACK FUNCTION IN CASE OF
OBSTACLE
The motor has a protection system, in case of encountering an obstacle the motor will reverse.
This option can be disabled by following these steps:
• Press the "P2" button on the remote once, located on the back next to the battery. Wait for
the motor to move.
• Press the "DOWN" button on the remote for 1 second. Wait for the motor to move.
• Press the "DOWN" button on the remote for 1 second. Wait for the motor to make 2
movements and 3 beeps.
• Settings OK.

8.7 CHANGE OPERATION IN CASE OF OBSTACLE

With the obstacle reverse function activated, the motor will follow one of the following behaviors:
the motor will stop; the engine will back off a few inches; the motor will reverse to the upper limit.
To change between these operations we will follow these steps:
• Press the "P2" button on the remote once. Wait for the motor to move.
• Press the "STOP" button on the remote for 1 second and wait for the motor to move.
• Press the "DOWN" button on the remote once.
• Settings OK.
57