Inhaltsverzeichnis
Werbung
7.
FRONT TILT
ADJUSTMENT
IMPORTANT
BEFORE STARTING WITH THE TILT ADJUSTMENT, WE RECOMMEND THAT TWO PEOPLE ARE PRESENT
TO CARRY OUT THE PROCESS SAFELY AND COMFORTABLY. REMEMBER NOT TO REMOVE THE
PROTECTIVE PLASTIC OR CLOTH FROM THE ARMS UNTIL YOU HAVE FINISHED ADJUSTING IT.
TILT ADJUSTMENT FROM 0º TO 45º
1.
Remove the plastic caps from the side brackets. Insert the Allen key into the front hole
and leave it in place during the process. It will help you to adjust the tilt more easily.
2.
Loosen the side screw shown in the picture, without loosening it completely.
3.
When you turn the allen key slowly clockwise, you will see how the arm goes up, whereas
if you want the arm to go down, you have to turn the allen key counterclockwise. Finally
tighten the screw that you had previously loosened in step 2.
38
TILT ADJUSTMENT FROM 50° UPWARDS
1.
Remove the plastic caps from the side brackets. Loose the hex head screw on the bracket.
This will allow you to detach the arm from the side bracket. When you separate the arm
you will see a circular piece with different holes as shown in the following picture:
2.
This piece must move according to the inclination you want to achieve. You must fit the
piece in one of the four deeper holes, depending on the level of inclination you wish to
achieve. The screws and nuts that go on the arm and support should be re-inserted and
tightened.
3.
Repeat the same steps on the other side of the awning. Finally, use a level tool to check
that the awning is leveled and fit the covers on both sides.
39
Werbung
Inhaltsverzeichnis
