Dry Mode; Sleep Function; Timer Function; Overload Protection - Polar GE959 Bedienungsanleitung

EN
Heat mode
Select the heat mode to increase the temperature
in your room.
1. Press Mode button until the HEAT mode
indicator lights up.
2. Press Up/Down buttons to set temperature.
3. Press Speed button repeatedly to select the
desired fan speed.
4. If desired, press Swing button to activate the
swing function.

Dry mode

Select this mode to dehumidify your room,
especially on hot humid days.
1. Press Mode button until the DRY mode
indicator lights up.
2. The fan will run at the low speed constantly.
Fan speed and temperature are not available to
adjust.
3. SWING function is applicable to use.
Note: Before using heating or drying
function, ensure to connect the supplied
drain hose to the upper drain outlet for
continuous operation.
Upper Drain outlet
Drain hose
Fan mode
Select this mode to ventilate your room. In this
mode the room air is circulated but not cooled.
1. Press Mode button until the FAN mode
indicator lights up.
2. Press Speed button repeatedly to select the
desired fan speed.
3. SWING function is applicable to use.
8
GE959_ML_A5_v1_20230104.indb 8 GE959_ML_A5_v1_20230104.indb 8

Sleep function

The sleep function can be activated when in cool
mode and heat mode.
In cool mode
1. After one hour the
preset temperature
is increased by 1°C.
2. After another
hour the preset
temperature is
increased again
by 1°C.
3. Temperature is kept constant for 10 hours.
And all the indicators dim to dark. The fan
speed may switch over to low speed for silent
operating and cannot be selected.

Timer function

With the timer function, you can set the time for
auto shut-down or start-up.
Auto shut-down
1. While operation,
press Timer button
to activate timer
function.
2. Press Up/Down
buttons repeatedly
to set the desired
timer setting.
3. When the set
timer expires, the
appliance will shut
down automatically.
Note: To cancel the timer at any time, repeatedly
press Up/Down buttons until "00" is shown.

Overload Protection

In case of an accidental power loss, after the
power resumes, there will be a 3-minute delay
before the compressor restarts.
In heat mode
1. After one hour the
preset temperature
is decreased
by 1°C.
2. After another
hour the preset
temperature is
decreased again
by 1°C.
Auto start-up
1. While in Standby,
press Timer button
to activate timer
function.
2. Press Up/Down
buttons repeatedly
to set the desired
timer setting.
3. When the set
timer expires, the
appliance will start
up automatically.
2023/1/4 17:37:20 2023/1/4 17:37:20