Remote Control - Polar GE959 Bedienungsanleitung

EN

Remote Control

4
5
6
7
8
Note: The remote control is powered
by 2x1.5V AAA batteries (not included).
Ensure to follow polarity markings when
inserting batteries.
Installation
Note: If the unit has not been stored or
moved in an upright position, let it stand
upright for approximately 24 hours before
operation. If in doubt allow to stand.
Choose the location
Place the unit on a firm, level surface in an area
with at least 50cm of free space around it to allow
proper air circulation.
Do not install the unit in a place where flammable
gas may leak.
NEVER install the unit where it could be subject
to:
• Heat sources such as radiators, heat registers,
stoves or other units that emit heat
• Direct sunlight
• Mechanical vibration or shock
• Excessive dust
• Lack of ventilation, such as cabinet or bookcase
• Uneven surface
6
GE959_ML_A5_v1_20230104.indb 6 GE959_ML_A5_v1_20230104.indb 6
1. Display
2. Power switch Press to turn the unit on or off
3. Heat
1
4. Cool
5. Dry
2
6. Fan
3
7. Up/Down
12
11
8. Timer
9. °C/°F
10
9
10. Sleep
11. Swing
12. Speed
Install the exhaust hose
The air conditioner requires to be vented outside
as the exhaust air coming from the appliance
contains waste heat and moisture.
Do not replace or extend exhaust hose to avoid
decreased efficiency, or even worse the accidental
shut-down of the unit due to low backpressure.
1. Connect the hose connector to one end of the
2. Connect the windows kit adapter to the other
Show temperature and timer setting
Press to enter the desired mode directly
Increase/Decrease temperature
(16°C-32°C) or timer setting (1-24h)
Set timer for auto start-up and shut-down
Press to toggle between Centigrade and
Fahrenheit
Press to turn sleep function on or off
Press to turn swing function on or off
Press to choose the fan speed of high,
middle or low
exhaust hose.
end of the exhaust hose.
2023/1/4 17:37:20 2023/1/4 17:37:20