Energetics CT 570 Bedienungsanleitung Seite 9

Step 6
Attach the Handlebar (27) to the Handlebar Post (13) and
secure with clamp, clamp decoration cover (87), star
handle screw (30) and washer (5) in your desired position.
Attach the handlebar cover (87+88)
with 2 screws M5x10mm (90).
Step 7
Attach the Computer Upper Cable (14) to the Computer
(22). A click can be felt when the Cable is attached.
Attach the Computer (22) to the Handlebar Post with 4 x
(23). Tighten with the screwdriver.
Step 8
Insert the Right Pedal (33) into the right arm of the Crank
assembly(34) and finger tighten in a clockwise direction
until the thread is fully inserted in the crank.
Repeat for the Left Pedal (33) finger tighten in an
anticlockwise direction. Tighten both with the spanner.
Step 9
Plug the Adaptor (35) into the rear of the bike and into the
main power, the console will beep when connected and
the power is turned on.
Well done !
Your bike is now ready for use. Please go to the computer operation section in this
manual for instructions on how to operate your console.
9