Reflexion LEDX22I+ Bedienungsanleitung Seite 58

CI Information
Signal Information
Auto Search
DVBT Manual Search
 IF Freq: Press the [
selection. Press the [
frequency. Select the IF (ID) corresponding to your
LNB or multi-switch and enter the frequency.
 Sat Position: Select Satellite Position: SatA, SatB
ToneBurst: Set the toneburst "On" or "Off" according to
your satellite system.
DISEqC 1.0: Only active if DISEqC 1.1 is switched off.
Adjust the setting according to your multi-switch
configuration.
DISEqC 1.1: Only active if DISEqC 1.0 is switched off.
Adjust the setting according to your LNB / multiswitch
configuration.
DISEqC 1.2: Motor settings. Activates the Limit Settings
menu item.
Motor Setting: Only active if DISEqC 1.2 is set to "On".
Set the position settings for the satellite.
Displays information about the inserted CI module and
card. Only active if a module is inserted. The module and
card are not included in the scope of delivery and must
be purchased separately from the reception provider.
Displays reception information of the selected station.
Only active when a station has been found.
DVB-T
Starts the automatic channel search. The channels are
automatically added to the channel list.
Country Select: Select the country according to the
installation site.
Search Type: Select the search type.
 ATV+DTV
 DTV (Recommended)
LCN Option: Set the LCN option "On" or "Off". It is
recommended to set it to "Off", otherwise the yellow
button in the "Edit Channel" menu is disabled.
Search: Starts the search.
Note:
 Please note that you must switch the option "5V
antenna voltage" "On" or "Off" according to the
antenna used before the search run.
Starts the manual channel search. The channels are
automatically added to the channel list.
Frequency: Displays the frequency of the transmitter.
58
] key to open the frequency
] key again to edit the
UK