Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
en
9
• Disconnect the appliance from the electrical grid and make sure that it cooled down completely before cleaning.
• If the power cord is damaged, it has to be replaced by the manufacturer or its service center or a similar qualified
specialist, to avoid any danger.
• The power cord may only be replaced with a genuine power cord, if it has any damages.
• Do not operate the appliance when it is out of order or faulty, bring it back to the closest authorized service center
or the manufacturer for inspection, repair or replacement. Do not attempt to disassemble it on your own.
• This appliance is designed for household use only, not for commercial use.
• The surface of the heating element has residual heat after use.
• Please keep this instruction.
2. diAgrAm of tHe APPliAnce
fig. 1
1. Control panel
2. Lid of the water tank
3. Water tank
4. Main body
5. Drip tray
6. Grill of the drip tray
7. Water feed channel (spout)
fig. 2
breAkdoWn of tHe control PAnel
lock – lock button
– press and hold it for about 3 to 5 seconds to unlock. Inaction for 10 seconds will result in
automatic lock. It is possible to forcibly lock by pressing the lock button.
temp. – temperature button
– set the temperature you need as follows: 45, 55, 65, 75, 85, 100 °C.
Volume – Volume button
– set the water volume as follows: 100, 200, 300, 400, 000 (continuous water flow).
milk – milk button
– pour milk powder (formula) into a bottle or cup, press and hold the milk button without loosen-
ing. The display will show the temperature of 40 °C. Release the button when you get the volume of water you need,
the appliance will immediately stop running.
coffee/teA – coffee/ tea button
– press the button and when the display shows 92°C, you can choose the
needed volume by holding the button or a fixed volume of 100, 200, 300, 400 ml. When the water volume is set, press
on/off button to get started.
stArt/stoP – stArt/stoP button
– setting up of start and stop features.
3. Pre-stArting Procedure
Should the appliance be exposed to a temperature differential, wait 1 hour for the body temperature to come to the
ambient temperature.
If you use the appliance for the first time, clean the water tank before use. Always pull out the plug and let cool down
before cleaning. Wipe the surface of the water tank with a damp cloth and polish it with a soft dry cloth. Fill it with
pure water for cleaning. During the first use, use up the water in the tank while you clean the appliance, and then refill
it with pure water.
3.1 fill WitH WAter
Open the lid, fill the water tank with the needed amount of water, and then close the lid. Use filtered water only. Do
not pour water directly from the tap into the installed water tank in order to prevent water from getting on electrical
connections and contacts inside the device body. This can damage your appliance.
DO NOT fill the water tank with hot water!
Werbung
Inhaltsverzeichnis
