Cleaning And Maintenance - Seg SWS 2001 Bedienungsanleitung

11
manually, press the LOCK button.
10. To turn off the appliance, disconnect it from the power supply. The control panel will go blank.
Attention!
If the power is turned off during the appliance operation, the selected settings will be reset.
4.2 bAby food ProgrAm
Use this program to prepare baby milk powder and baby food. Press and hold the MILK button. The appliance will
feed water at 40°C until you release the button. Release the button when the required volume is reached.
4.3 coffee/teA ProgrAm
Use this program for brewing tea and making instant coffee.
1. Press the COFFEE/TEA button. The temperature indicator will show 92°C.
2. Use the VOLUME button to set the water volume as follows: 000, 100 ml, 200 ml, 300 ml, 400 ml in a sequential
adjustment mode.
3. Press the START/STOP button to start feeding water.
4. The water feed will stop with the reach of the programmed volume. To stop the water feed, press the START/STOP
button again.
5. If the volume was set to 000 ml, press the START/STOP button again when the required volume is reached.

5. cleAning And mAintenAnce

Always pull out the plug and let cool before cleaning, wipe the surface of the water tank with a damp cloth and polish
with a soft dry cloth and fill in pure water.
• Always turn the dispenser off and pull the plug out from the socket and let it cool down completely before cleaning.
• Do not immerse the appliance in liquid to avoid damage and breakdown.
• To maintain long-term serviceability, descale the appliance when the descaling indicator light flashes on the display.
When the usage time reaches the sum of 10 hours, the descaling indicator light on the display will flash, reminding
that you have to descale the appliance, fill the tank with water to the maximum level, add a little citric acid or vinegar
to the water - it will help to remove the scale better, hold the volume button for about 3 seconds to go to descaling
process, let the water flow out until the tank is empty. The descaling indicator light will stop flashing if the cleaning
process is successful.
• Do not use any chemicals, metal, wood or abrasives to clean the body of the appliance, always use a damp cloth.
• Handle the appliance with care, do not put it on the edge to protect it from deformation, damage or malfunction due
to an accidental falling off a table.
Removal of water from the drip tray
If the drip tray is full, hold the appliance with one hand and the drip tray with the other. Lift the drip tray slightly to pull
it out of the grooves. Empty the drip tray and insert it back into the appliance. Make sure that the drip tray is inserted
correctly.
After cleaning the appliance, unscrew the drain plug to purify the waste water. Tighten up the drain plug after opening
it. (see figure 5)
5.1. troublesHooting
Error code E7
Display shows Temperature sensor E5
Display shows Temperature sensor E4
Lack of water. Fill the tank with water to the maximum level
There is a problem with the water inlet. Bring the appliance to the after-
sales service center to have the temperature sensor checked or replaced
There is a problem with the water outlet. Bring the appliance to the
after-sales service center to have the temperature sensor checked or
replaced
en