cecotec Cumbia Cafelizzia 790 Steel Bedienungsanleitung Seite 19

ENGLISH
- Once the 1-coffee and 2-coffee light indicators remain steady, press the 1-coffee button.
The machine will start the cleaning process.
Warning
If you want to carry out a more thorough cleaning cycle of the device's inside parts, use a 1:4
solution of vinegar and water, or use descaling product. Repeat this process just with water to
remove any rests.
3. OPERATION
- Fill the water tank without exceeding the MAX mark. Use mineral water for better
maintenance of the device.
- Connect the coffee machine to a power supply and make sure the steam knob is in the off
position. Turn on the coffee machine.
Espresso
While the machine preheats, place the desired coffee filter in the portafilter and fill it with
coffee powder. Use the measuring spoon/coffee tamper to pour and press coffee down. 1
tablespoon is equal to 1 coffee dose. Clean the excess coffee from the filter's edge.
Fig. 3.
Insert the portafilter in the device and lock it tightly.
Fig. 4.
Once the 1-coffee and 2-coffee light indicators switch from blinking to steady, press the
desired coffee button for the machine to brew 1 or 2 coffees.
Warning
Make sure you have previously placed an appropriate cup or cups under the coffee spout.
Milk froth
- With the machine switched on and preheated, press the steam button. The steam indicator
light will flash and then remain steady when the preheating process is complete.
- Pour milk into the container where you want to froth milk. Fill up 1/3 of the container.
- Recommendation: It is recommended to use cold whole milk for optimal results.
- Place an empty glass under the frother, turn the steam selector to the steam/water
position, and let the tube emit steam before frothing the milk. Once steam is emitted,
deactivate the steam function by returning the steam selector to the off position, insert
the 1-cm steam tube into the milk, and turn the steam selector slowly counterclockwise
until steam is produced.
Fig. 5.
36
1. Off
2. Steam/water
Warning
The vaporiser may emit a few drops of water before producing steam.
When milk temperature starts to rise (to up to 75 ºC) and milk froth volume starts increasing,
turn the steam knob clockwise to the 0 position and press the steam button to stop the steam
function.
Warning
Clean the steam outlet with a wet sponge immediately after use. Then, remove the steam tube
and clean the duct interior part. Moreover, it is advisable to emit steam into an empty glass to
get rid of any traces of milk left.
Hot water
- With the coffee machine switched on and preheated, turn the steam selector to the steam/
water position. The steam tube will start dispensing hot water.
- Turn the steam tube back to the 0 position to deactivate this function.
Memory function
- Once the coffee machine has preheated and 1-coffee and 2-coffee light indicators remain
steady, hold down the 1-coffee button. The machine will start brewing coffee.
- When you have obtained the desired amount of coffee, stop pressing the espresso button.
The machine will emit a sound, indicating it has saved the quantity.
- The coffee machine brews coffee 60 seconds approx. by default, which is the maximum
time coffee can be brewed and saved.
Warning
The setting will not be registered and saved unless the button is pressed for long enough.
If you want to prepare a larger espresso or 2 espressos, follow the steps above and use the
2-coffee button instead of the 1-coffee one.
Factory settings
If you want to restore factory settings, hold pressed the 1-coffee button and the steam button
for 3 seconds. The device will beep once indicating factory settings have been successfully
restored.
Device cooling process
- After steam is emitted or coffee is brewed, the device's temperature is likely to increase
ENGLISH
CAFELIZZIA 790 STEEL 37