Technical Data - BOMANN GSP 7411 IX Bedienungsanleitung, Garantie

Malfunction / cause / action
Noises
- Make sure all dishes are secured in the dish-
washer.
- Place items so that the spray arms can rotate
freely.
Foaming
Use only special dishwasher detergent to prevent
foaming. Should this occur, open the dishwasher
door and allow the foam to escape. If necessary,
add some cold water to the tub. Start a rinse cycle
to drain the water.
Plates, other flatware is not clean
- Select a stronger program.
- Make sure that the function of the spray arms is
not blocked by large dishes.
Stains and film formation
- Extremely hard water.
- Low inlet temperature.
- Overloading, incorrect loading.
- Old or damp detergent.
- Incorrect detergent dosage.
Staining of glassware
Use less detergent with soft water and select the
shortest rinse cycle to clean and rinse glassware.
Black, gray stains
Dishes were in contact with aluminum parts. Use a
mild scouring agent to remove these stains.
Stains on inner pan
Only use cleaning agents without dyes.
White film inside the appliance
Minerals in hard water: Use a damp sponge with
dishwasher detergent. Wear rubber gloves when
doing so.
Unsatisfactory drying result
- Incorrect loading.
- Dishes are removed too early.
- Incorrect program selection.
- Use of cutlery with poor coating.
Error codes
In case of some malfunctions, the appliance displays
the following error codes to warn you:
Code Meaning / possible cause
Water inlet fault! Faucet not open, inlet
E1
blocked or water pressure too low.
Malfunction of the heating element!
E3
Rinsing temperature is not reached.
E4 Overflow / water leakage!
Communication error between main and
Ed
display board.
CAUTION:
• In case of water leakage, close the main valve
before contacting an authorized technician.
• If there is water in the lower part of the housing
due to overfilling or a small leak, remove this wa-
ter before restarting the appliance.
NOTE:
If a problem persists after following the steps above,
contact your distributor or an authorized technician.

Technical data

Electrical connection / water supply........................
Connection voltage: ..................220-240 V~ / 50 Hz
Rated power: .................................1760 – 2100 W
Rated current: .............................................10 A
Water pressure: ................................0.04 – 1 Mpa
Dimension H x W x D / weight................................
Unit size: ..............................84.5 x 44.8 x 61.0 cm
Net weight: ..........................................ca. 35.0 kg
Available accessory............................................
Inlet hose safety system: .............Art.-No. 8900 410
For more information about the product, scan the QR
code on the supplied energy label and/or visit the
official website of the product data bank:
https://eprel.ec.europa.eu
39