Insert the trolleys "legs" into the holes on the bracket and adjust the track width with spacers and
washers so that it fits your beam.
Now the trolley/electric hoist can be mounted on the beam. Two people are required for this task!
TIP: You might want to mount the trolley so that the motor is on the same side as the motor of the
electric winch - that way the two remote controls will be located on the same side.
Make sure to tighten the castle nuts well (remember the split!) and tighten the balance wheel so
that the trolley is fixed against the beam.
7
MAN 9039906 EN V2
P. Lindberg A/S
Sdr. Ringvej 1
www.p-lindberg.dk
Tlf: 70212626
DK-6600 Vejen
e-mail: salg@p-lindberg.dk