Frame Test Without Table Top - actiforce Skagerrak Montageanleitung

3.14 Frame test without table top

Please make sure that the workstation frame can move freely and correct at all times.
In case you need to disconnect cables from the electrical components always be sure
to disconnect power first.
In case the height adjustment is not operating normally, stop using the workstation frame
immediately and disconnect the power. Get in contact with customer service for further
advise
Reset Mode
At first start up, when the table legs have an uneven height or if the wrong height is indicated, a re-
set is required.
The first time you put in the plug of the power supply into the socket the height adjustment can only
be operated in the reset-mode. As long as the reset-mode is enabled, the system can only move
downward. In order to use the system normally, please follow the next steps:
UP
LM2LC
• Press the "down" arrow key 4 times quickly one after another.
• Pressing the "down" arrow key once again will now initiate the reference run. The key must be
kept pressed until the table reaches its reference position and then moves back the set dis-
tance. Now the reference is recalibrated, the table should be leveled, and the height indication
should be correct. If a power failure occurs or the mains plug is being pulled out while traveling,
the controller will go to reset mode automatically.
DOWN
Eco Basic Slide
• Press and hold the down-button, the system slowly moves downward.
• Please move the system to the lowest position. This position will be used as reference-point (zero-
point).
• Keep the button pressed for a moment when the system has reached the lowest position. This
will end the reset-mode.
• The system can be operated normally now. Press and hold the up- or down-button to move the
system to the desired height. The system stops when you release the buttons.
Functions of the Pro Memory (Optional)
For actiSwitch Pro Memory
Assembly Instruction, please refer to Manual
SLS-IM0061
DOWN
UP
UP
LD2EC
UP
Pro Basic
For actiSwitch Eco Memory
Assembly Instruction, please refer to Manual
SLS-IM0081
English
DOWN
DOWN
26