Table Test - actiforce Solid 670 Betriebs- Und Montageanleitung

EN

3.4.5 Table test

Please make sure that the table can move freely and correct at all times
In case you need to disconnect cables from the electrical components always be sure
to disconnect power first.
In case the height adjustment is not operating normally stop using the table immedi-
ately and disconnect the power. Get in contact with customer service for further advise
(see Section 10).
Left button
Up
Reset mode
The first time you put in the plug of the power supply into the socket the height adjustment can
only be operated in the reset-mode. As long as the reset-mode is enabled, the system can only
move downward. In order to use the system normally, please follow the next steps:
– Press and hold the down-button, the system slowly moves downward.
– Please move the system to the lowest position. This position will be used as reference-point
(zero-point).
– Keep the button pressed for a moment when the system has reached the lowest position.
This will end the reset-mode.
– The system can be operated normally now. Press and hold the up- or down-button to move the
system to the desired height. The system stops when you release the buttons.
English - 14.
Right button
Down