Restore To Factory Settings - Pixsys MCM260X Installationsanleitung

TerM Line termination resistance status
Indicates the status of the line terminator of the module. The terminator must be activated in the
last module present on the communication line (both in CAN and in RS485).
(default)
OFF
Old.C Compatibility mode with the old version of MCM260
Only for MCM260X-1,2,3,4,5AD.
Indicates whether the module must work in compatibility mode with the old MCM260-xAD
version. By setting the compatibility to
MCM260-xAD; therefore, to use it please refer to the manual of the old model (code: 2300.10.070).
This mode is useful when replacing modules that no longer work in existing systems.
= No-compatibility with the old MCM260 version. Use this selection in system with
no.L.L.
LogicLab CAN/Modbus master
= Full-compatibility with the old MCM260 version
YES
= No-compatibility with the old MCM260 version. This selection activate the standard
no.C.o.
CANopen slave mode
Comp. CAN Compatibility mode
Only for MCM260X-9AD.
Indicates if the module must work in systems with Master CAN LogicLab or Master CANopen.
= Use this selection in systems with LogicLab CAN master
L.LAb.
= Use this selection in systems with standard CANopen master. This selection activate
CAMo.
the standard CANopen slave mode
PASS Password to access the configuration parameters
Indicates the password that must be entered when accessing next, to change the configuration
parameters through both the terminal and the MyPixsys app.
Set a personalized password, different from the default one (
access to the configuration of the module to unauthorized personnel.
Pay close attention when changing this parameter and keep the set password in a safe
place.
If you do not know the password it will not be possible to access and change the parameters!
(default 1234)
OOOO...8888
nFc.L NFC functionality block
Indicates whether the NFC functionality block (change of the parameters through the MyPixsys
app) is active (
level of security of the module configuration and prevent unauthorized people from accessing
and changing the data.
(default)
diS
Enab
5.6

Restore to factory settings

You can restore the configuration parameters to their factory settings by entering the password
The reset can also be performed from the MyPixsys app by loading the default parameters from the
specific menu.
Warning: using this procedure in a module present in a plant could compromise the operation of
the entire system.
24 - MCM260X - User manual
120 100
) or not ( ). Blocking the NFC functionality may be useful to increase the
Enab diS
, the module will behave exactly like the corresponding
YES
). It may be useful to prevent
1234
.
9999