Use; Device Overview; Operation; Led Status Display - Intenso BSA2 Bedienungsanleitung

USE

Device overview

1 - Status LED
2 - USB-C IN

Operation

LED status display

The current operating status of the device is indicated by the status LED. If you connect the
device to a connected power supply unit, the LED flashes green once and blue once as confirmation and
then remains off. If a charging process is started, the LED lights up blue continuously. When the terminal is
fully charged, the LED usually changes from blue to green (depending on the charging device). If the LED
flashes blue quickly, there is an error – for example, the device is not positioned correctly, it has become
too hot, there is a foreign object between the devices or an incompatible power supply unit is being used.
Start-up / charging compatible devices
Step 1: Preparation
Connect the supplied USB-C to USB-C cable to the USB-C port (IN) of the inductive charging station and
connect the other end of the USB cable to the power supply unit. Next, connect the power supply unit to a
power socket (follow the safety instructions).
Step 2: Start charging
Place your Qi-compatible device in the centre of the inductive charging station; you can choose either a
horizontal or vertical orientation. The charging process starts automatically, and the status LED lights up
blue continuously.
If this is not the case, please check
a. whether your device is Qi-compatible
b. whether there is a foreign object between the devices or you are using an unsuitable case.
c. whether you have chosen the enclosed power adapter or a different but compatible one. If this is
not the case, replace it accordingly. If this is the case, please disconnect it from the power supply for
a few seconds and reconnect it to start the charging process.
d. whether the cable ends and the power supply unit are correctly connected.
e. where the correct wireless charging position is on your device. You may need to reposition it.
Please note that the ambient temperature and the charging electronics of the device to be charged have
an effect on the charging behaviour over which the inductive charging station itself has no influence. For
example, the charging speed may be reduced at increased temperatures or when charging levels have
already been reached.
Step 3: End charging process
To end the charging process, simply remove your device from the inductive charging station.
1
EN - Page 4 of 5
2