Cleaning, Care & Maintenance; Replacing The Interior Lamp; Cleaning The Condenser - Polar GH506 Bedienungsanleitung

Cleaning, Care & Maintenance
Switch off and disconnect from the power supply before cleaning.
• Clean the interior of the appliance as often as possible.
• Do not use abrasive cleaning agents. These can leave harmful residues.
• Clean the door seal with water only.
• Always wipe dry after cleaning.
• Do not allow water used in cleaning to run through the drain hole into the evaporation pan.
• Take care when cleaning the rear of the appliance. Sharp edges can cut.
Condensation will form in refrigeration with frequent opening of the doors and on hot humid
days, please ensure condensation is allowed to drain properly or is wiped dry.

Replacing the Interior Lamp

WARNING: Allow the lamp to cool before replacing. The lamp remains hot
immediately after use.
1. Turn Off and disconnect the appliance from the mains power supply.
2. Unscrew the plastic lamp cover.
3. Remove the lamp by twisting it from the lamp sockets.
4. Insert the new lamp and replace the cover.

Cleaning the Condenser

• The condenser is part of the refrigeration system. The condenser requires monthly cleaning.
• Always disconnect power supply before carrying out Routine Maintenance.
• Failure to clean the condenser will reduce the performance and life of your Polar unit and may
invalidate your warranty.
• The condenser is located below the refrigeration cabinet behind a removable panel (see below).
These models have a removable filter which can be cleaned with a vacuum cleaner.
GH506
GH506_GH507_ML_A5_v6_20220914.indb 5 GH506_GH507_ML_A5_v6_20220914.indb 5
GH507
EN
5
2022/9/14 11:32 2022/9/14 11:32