Cleaning And Maintenance - RONDELL RDE-1110 Betriebsanweisung

LANGUAGE
By consecutively pressing the «LANGUAGE» icon, you can
select your preferred languages or just use the icons.
COUNTER
Press the «COUNTER» icon to view the number of different
drinks that have been made with your coffee machine.
CALIBRATION
This mode is intended for technical specialists of service
centers.

CLEANING AND MAINTENANCE

Cleaning the milk system
1. When the message «CLEANING THE MILK SYSTEM»
appears on the display, press the «
will show a picture with further instructions. Remove the
milk tube from the milk container, or disconnect it from
the thermal container lid (21) if you used a thermal con-
tainer. Attach the free end of the tube to the tip lock
(fig. 21) and position it as shown on the display.
2. Press the « » icon, the coffee machine will start dis-
pensing hot water through the milk tube and frother (3)
outlets. After a while, hot water dispensing will stop and
after additional heating, steam dispensing will begin.
When the cleaning process is finished, the main menu will
appear on the display.
Drain the liquid from the tray (1).
ATTENTION! Do not touch the coffee dispensing unit (2)
during this operation to avoid burns.
Cleaning milk frother outlets
1. Insert the milk frother (3) into the coffee dispensing unit
(2) (fig. 17).
2. Place the milk tube into a container with clean water and
place a cup under the coffee dispensing unit (2) (fig. 20).
3. Press the «MILK» icon on the main menu to start
cleaning.
4. In the end drain the cup and repeat the above steps
until the outlets are flushed and completely cleaned of
old milk.
Flushing the milk froather
1. Press the locks on the milk frother (3) (fig. 19) and
remove it from the coffee dispensing unit (2).
2. Put the frother into a container with warm clean water for
a while, then rinse it and dry it.
3. Put the milk frother back into the coffee machine
(fig. 18).
Cleaning the coffee bean container
– Unplug the unit from the mains.
– Open the coffee bean container lid (19) and clean
the inside of the coffee bean container (10) with a dry
soft cloth.
ATTENTION! Do not use water or sharp objects to clean
the container (10).
Cleaning the brewing unit
Notes: We recommend cleaning the brewing unit once
a month.
1. Open the brewing unit compartment door (11) (fig. 27).
2. Remove the used coffee grounds container (13)
(fig. 28).
3. Press the lock of the brewing unit as shown in (fig. 29)
» icon. The display
and remove it from the coffee machine. Put the brew-
ing unit (12) in a container with warm clean water for a
while, then clean it with a soft brush (supplied with the
unit), rinse it thoroughly under running water and dry it.
4. Clean the brewing unit compartment from ground
coffee residue (fig. 30) and wipe it with a soft, slightly
damp cloth.
5. Put the brewing unit back to its original place and
press lightly until a characteristic click confirms that it
is properly installed (fig. 31).
6. Insert the used coffee grounds container and close the
compartment door (fig. 32).
COFFEE MACHINE CLEANING MENU
To go to the coffee machine cleaning menu, press the
«MENU» icon on the main menu (fig. 7) and go to the
settings menu (fig. 8). Press the «CLEANING» icon on
the settings menu and go to the coffee machine cleaning
menu (fig. 33).
As required, press the desired icon, the display will show
an icon with the corresponding process, follow the in-
structions on the display.
– Pressing the «FLUSHING» icon starts the flushing
mode of the water dispensing system, the system
flushing icon will appear on the display (fig. 34).
– Pressing the «CLEANING THE MILK SYSTEM» icon
starts the cleaning of the milk system (see description
above), the icon will appear on the display (fig. 35). To
start the process, click the «
ther instructions.
– Pressing the «BREWING UNIT» icon starts the brew-
ing unit (12) cleaning process, the display will show
the brewing unit cleaning icon (fig. 36). To start the
process, click the «
27
» icon and follow fur-
» icon and follow further instruc-