Technical Data - AEG BSL18 Originalbetriebsanleitung

TECHNICAL DATA

Type
Production code
Wattage
Battery voltage
Run time with one fully charged battery (Li-ion 9.0 Ah)
Colour temperature
Beam angle
Weight without battery pack
Recommended battery types
Recommended charger
WARNING! Read all safety warnings, instructions,
Failure to follow all instructions listed below may result in electric
STICK LIGHT SAFETY WARNINGS
The light source of this luminaire is not replaceable. When the light
source reaches its end of life, the whole luminaire shall be replaced.
Do not direct the light beam at persons or animals, and do not stare
into the light beam yourself (not even from a distance). Staring into
Use only with recommended battery pack and charger. Any attempt
to use another battery pack will cause damage to the product and
Do not disassemble the product.
allow the lens to come in contact with anything.
surface.
Remove the battery pack before starting any work on the product.
Do not store the product in a damp or wet location, or in a location
SPECIFIED CONDITIONS OF USE
The stick light is intended for general illumination. Do not use the
product in wet conditions.
Do not use the product for any other purpose.
ADDITIONAL BATTERY SAFETY WARNINGS
WARNING!
product damage due to a short circuit, never immerse your tool,
chemicals, and bleach or bleach containing products, etc., can
cause a short circuit.
Do not dispose of used battery packs in the household refuse or
protect our environment.
Use only AEG chargers for charging AEG battery packs. Do not use
battery packs from other systems.
Never break open battery packs and chargers, and store them only
in dry rooms. Keep battery packs and chargers dry at all times.
Battery packs that have not been used for some time should be
recharged before use.
of overheating).
The contacts of chargers and battery packs must be kept clean.
For an optimum life-time, the battery packs have to be fully charged
after use.
To obtain the longest possible battery life remove the battery pack
from the charger once it is fully charged.
For battery pack storage longer than 30 days:
• Store the battery pack where the temperature is below 27°C and
away from moisture.
• Store the battery packs in a 30% - 50% charged condition.
•
BATTERY PACK PROTECTION
The battery pack has overload protection that protects it from being
overloaded and helps to ensure long life.
discharged completely. Recharge the battery pack.
TRANSPORTING LITHIUM BATTERIES
Legislation requirements.
Transportation of those batteries has to be done in accordance with
local, national and international provisions and regulations.
• Batteries can be transported by road without further requirement.
•
trained persons and the process has to be accompanied by
• Ensure that the battery contact terminals are protected and
insulated to prevent short circuit.
• Ensure that the battery pack is secured against movement within
the packaging.
• Do not transport batteries that are cracked or leaking.
Check with the forwarding company for further advice.
MAINTENANCE
Use only AEG accessories and spare parts. Should components
that have not been described need to be replaced, contact one
addresses).
the product type and the serial number printed on the label,
and order the drawing at your local service agents or directly
Winnenden, Germany.
ENGLISH
BSL18
LED stick light
4756 95 01 XXXXXX MJJJJ
8 W
18 V
18 hr
5000 ± 250 K
120°
0.38 kg
0.8 ... 1.5 kg
L18...
AL18G, BL1...
13