Assembly And Preparation - Max 31139 Gebrauchsanweisung

Assembly and preparation

Place a mat or a piece of cardboard on the
� oor so that the parts do not get scratched or
damaged.
Remove all the parts from the packaging and
place the bench circular saw upside down on
the � oor.
Assembling the frame
See � gures 15, 16 and 17.
Lay out all the parts of the frame to get an
overview of how to assemble it.
Wait to fully tighten the screws and nuts
until all the parts of the frame have been
assembled.
Screw a leg (29) at each corner of the bench
circular saw using hex screws (b).
Screw the short cross braces (30) and the
long cross braces (31) securely to the legs
(29) using hex screws (b) and nuts (c). The
long cross braces (31) must be � tted parallel
to the sides of the bench circular saw.
Tighten all screws and nuts.
Fit the rollover brackets (A) to the rear legs
(29) so that they point backwards to prevent
the saw from tipping backwards.
Attach a rubber foot (13) to the end of each
leg (29).
Fit the tool hook (34) on one of the front legs.
At least 2 people are needed to lift the saw
and turn it over so that it is standing on its
legs.
54
Fitting bench extensions
See � gure 18.
Wait to fully tighten the screws and nuts until
all the parts have been assembled.
Fit the bench extensions (33) to the saw
bench (1) using hex screws (b) and nuts (c).
Fit 2 supports (32) to each bench extension
(33) and make sure that they are � ush with
the saw bench.
Tighten all screws and nuts.
Fitting the blade guard
See � gure 3.
Lower the saw blade as much as possible by
turning the handwheel (8).
Fit the blade guard (2) to the cleaver blade
(5) using the screw (15) through the hole (18)
in the cleaver blade. Do not tighten the screw
(15) too much as the blade guard (2) must be
able to move freely.
Check that the blade guard cannot come into
contact with the saw blade.
Check that the blade guard lifts when you
push the work piece towards the saw blade.