Assembly And Preparation - Max 31131 Gebrauchsanweisung

Assembly and preparation

Place a mat or a piece of cardboard on the
fl oor so that the parts do not get scratched or
damaged.
Unpack all the parts.
Lay out all the loose parts as shown in fi gure
4. Check that all the parts are present and
that there is no sign of transport damage.
If possible, save the packaging throughout
the warranty period.
Note!
• Make sure that the saw is not plugged
into the mains power before you
continue!
• Check that the saw blade is correctly
adjusted so that it does not protrude
above the surface of the saw bench.
• Use the ring spanners provided to
assemble or carry out maintenance on
the circular bench saw.
Fitting bench extensions
See fi gure 5.
Do not tighten the bolts fully until all the
parts have been fi tted.
Place the circular bench saw upside down on
the ground.
Position the bench extensions (8) so that
they are aligned with the sides of the saw
bench (1).
Attach the bench extensions (8) to the saw
bench (1) using cross-braces (21c) and bolts
(19).
Attach 2 supports (21a/21b) to each bench
extension (8) and cross-brace (21c) using
bolts (19).
34
Assembling the frame
See fi gures 6, 6.1, 7 and 7.1.
Lay out all the parts of the frame to get an
overview of how to assemble it.
Wait to fully tighten the bolts until all the
parts of the frame have been assembled.
Screw a leg (16) securely to each corner of
the circular bench saw using 2 bolts (19).
Note that the supports (21a/21b) must be
fi rmly screwed to the legs.
Attach a rubber foot (16a) to the end of each
leg (16).
Screw the short cross-braces (18) and the
long cross-braces (17) securely to the legs
(16) using bolts (19) and nuts (20). The long
cross braces (17) must be fi tted parallel to the
sides of the circular bench saw.
Tighten all bolts and nuts.
Attach the anti-tip mechanisms (16b) to the
rear legs (16) using bolts (19) and nuts (20) so
that they point backwards and will prevent
the bench from tipping backwards.
At least 2 people are needed to lift the saw
and turn it over so that it is standing on its
legs.
Fitting the cleaver blade
See fi gures 8, 9 and 10.
Position the saw blade vertical (0°) and raise
it as much as possible by turning the hand
wheel (12).
Loosen the countersunk screw (23) using a
screwdriver and lift the bench inlay (2) up.
There must be at least 3-5 mm between the
saw blade (3) and the cleaver blade (6).
Loosen the assembly screw (24).
Raise or lower the cleaver blade (6)
Retighten the assembly screw (24) and
replace the bench inlay.
If the bench inlay is worn down, it must be
replaced.