Cleaning And Maintenance - Steinberg Systems SBS-EH-500/3 Bedienungsanleitung

1) Verify that the Emergency Stop If the emergency stop switch is depressed, turn it
in the direction of the arrow symbols to allow the machine to operate.
2) Press the switch according to the up arrow to lift the load.
3) Press the switch according to the down arrow to lower the load.
4) If the load is lifted upward and the operator does not stop the machine early
enough, the stop puck will move the lever upward and the limit switch will be
activated. The machine will cease upward movement.
5) If the load is lowered down and the operator does not stop the machine early
enough, the bottom limit puck will move the lever and the limit switch will
activate. The machine will cease downward movement.
6) In an emergency situation, press the red button immediately to stop the machine.
It is not possible to operate the machine while the emergency stop switch is
depressed.
7) In the event of an overload, the winch speed is noticeably slower, jerking may
occur or the load may not be lifted at all. In addition, if the winch is loaded above
the rated capacity, the clutch may make a characteristic noise. In this case,
immediately release the "Up" button to stop the machine, and then reduce the
weight. After that, the machine can work again.

3.4. Cleaning and maintenance

a) Pull the mains plug and let the unit cool down completely before cleaning,
adjusting or replacing accessories and when the unit is not in use.
b) Use only non-corrosive cleaning agents for cleaning the surfaces.
c) After each cleaning, all the parts should be dried well before the unit is used
again.