Working With The Device; Cleaning And Maintenance - Steinberg Systems SBS-FZ 2000/6M Bedienungsanleitung

Each time check the control chain - whether it is not twisted and whether
•
it is properly arranged, i.e. the links are aligned.
3.3.

Working with the device

Lifting/lowering
Place the hook directly above the load so that it is not under tension and
•
the hooked load rests firmly on the ground.
To raise/lower the load, pull the control chain responsible for
•
lifting/lowering - lifting/lowering can be stopped at any time.
WARNING: in exceptional cases, the emergency brake may become hot
for devices that are used intensively during continuous lowering.
Always lower the load slowly and in stages. Stop the work immediately if
•
the chain becomes jammed or any other fault occurs. In such acase, notify
your supervisor or a responsible person who can safely remove the load
and restore the normal operation of the device.
IMPORTANT: when unlocking the load lifted on the device, additional
force may be required to release the friction between the brake
components - this is normal and does not constitute a defect of the
device!
3.4.

Cleaning and maintenance

a) Use only non-corrosive cleaning agents for cleaning the surfaces.
b) Store the unit in a dry and cool place protected from moisture and direct
sunlight.
c) Do not spray the unit with a stream of water or immerse it in water.
d) Perform regular inspections of the unit, checking technical fitness and any
damages.
e) Do not use sharp and/or metal objects (e.g. wire brush or metal spatula) for
cleaning as they may damage the surface of the appliance material.