Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
j)
Avoid situations in which the device stops under heavy loads during operation.
This can cause overheating of the drive elements and consequent damage to
the equipment.
k)
Do not touch any moving parts or accessories unless the device is unplugged.
l)
Clean the device regularly to prevent permanent dirt build-up.
m)
The product is not a toy. Cleaning and maintenance must not be performed by
children without adult supervision.
n)
Do not tamper with the device to alter its performance or design.
o)
Keep the unit away from sources of fire and heat.
p)
Do not block the ventilation openings of the unit!
q)
Using the unit to carry weights exceeding its maximum load is forbidden.
r)
Do not allow people or animals to stand under suspended loads.
s)
Transporting the load by means of the unit over people or animals is
prohibited.
t)
Transporting people or animals by means of this unit is prohibited.
u)
When transporting with the unit, avoid shocks, impacts and sudden changes
in speed. This will reduce the risk of the load falling from a height.
v)
Before suspending the load, always ensure that the space in which it will be
transported is clear of obstructions.
w)
Bystanders should be warned of the operation of the equipment and should
stay at a safe distance from the load.
x)
Always pay close attention to the load.
y)
Do not leave suspended loads unattended.
z)
Avoid rocking the load.
aa) Do not perform mechanical or similar work (welding, cutting, etc.) on
suspended loads.
bb) If the load falls, there is a risk of injury or death.
cc) Do not walk or stand under suspended loads (or in their immediate vicinity).
dd) When using the machine, it is forbidden to pull the chain in any direction other
than along the track. Pulling sideways may damage the device.
ee) Do not use excessive force or jerk the cable if resistance is encountered.
ff)
Avoid switching on/off sequences at very short intervals.
gg) Make sure that the equipment moves in the direction specified by the controls.
hh) Disconnect the unit from the power supply when not in use.
ii)
Do not move loads that are pinned to the ground or blocked by other objects.
jj)
Loads must be lifted off the ground at the slowest possible speed.
kk) The permissible load is constant and does not depend on the position in which
the load is placed.
ll)
The device is not designed for continuous operation. Observe the operating
cycle of the device.
mm) If the equipment is used in noisy environments, the operator should wear
hearing protection.
Werbung
Inhaltsverzeichnis
