Preparation For Operation; Working With The Device - Steinberg Systems SBS-EH-500/3 Bedienungsanleitung

3.2. Preparation for operation

ASSEMBLY OF THE UNIT
Before attaching the machine to the work area, check that it is not damaged. The
structure used for suspending must be able to withstand a load several times
greater than the maximum allowable load of the machine. Hang the machine on the
mounting hook.
Improperly suspending the machine can make it to fall, become damaged, injure
people or kill them.
It is forbidden to mount the machine on a structure that cannot be verified in
terms of its load-bearing capacity and strength.
The responsibility for mounting on a support structure and for the support
structure itself rests with the user. Special care must be taken when attaching the
machine to the supporting structure, and all conditions for safe operation must be
ensured in order to avoid hazards resulting in possible personal injury. The user is
responsible for preparing the installation conditions for the machine and for the
installation itself.
After mounting the machine, check that the hook is properly mounted and that
the latch is closed. Always periodically check brake operation when lifting a load.
To do this, use a test load (approx. 10% of the permissible load) and raise and
lower it several times to be sure that it will not slip off when lifting/lowering is
stopped.
It must be possible to disconnect the device from the power supply at any moment.
Ensure that the power supply to the unit corresponds to that specified on the
identification plate!
Ambient conditions
The following table shows the permissible ambient conditions under which the
machine can operate safely
Ambient temperature during device
operation [°C]
Relative humidity [%]
Altitude [m above sea level]
Temp. of transport and storage [°C]

3.3. Working with the device

Equipment Controls
0 ~ 40
< 85
-25 ~ 55
< 1000