Hilti NURON RT 6-22 Original Bedienungsanleitung Seite 28

7.3 Check of jaw housing correct seating
1. Use an open-ended wrench of the correct size to slacken the steel sleeve.
2. Completely unscrew the steel sleeve.
3. Check that the jaw housing is seated correctly.
4. If applicable, completely screw the jaw housing back on to the adapter.
5. Screw the sleeve on again.
6. Use an open-ended wrench of the correct size to tighten the steel sleeve.
8 Transport and storage of cordless tools and batteries
Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery/batteries.
▶ Never transport batteries loose and unprotected. During transport, batteries should be protected from
excessive shock and vibration and isolated from any conductive materials or other batteries that may
come in contact with the terminals and cause a short circuit. Comply with the locally applicable
regulations for transporting batteries.
▶ Do not send batteries through the mail. Consult your shipper for instructions on how to ship undamaged
batteries.
▶ Prior to each use and before and after prolonged transport, check the product and the batteries for
damage.
Storage
WARNING
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the product and the batteries in a cool and dry place. Comply with the temperature limits stated in
the technical data.
▶ Do not store batteries on the charger. Always remove the battery from the charger when the charging
operation has completed.
▶ Never leave batteries in direct sunlight, on sources of heat, or behind glass.
▶ Store the product and batteries where they cannot be accessed by children or unauthorized persons.
▶ Prior to each use and before and after prolonged storage, check the product and the batteries for
damage.
9 Troubleshooting
If a problem occurs, always observe the charge-status and fault indicator of the battery. See the section
headed Status indicators of the Li­ion battery.
If the trouble you are experiencing is not listed in this table or you are unable to rectify the problem by
yourself, please contact Hilti Service.
Trouble or fault
Battery does not engage with
an audible click.
Overload LED flashes for 10
seconds.
Blind rivet is not set.
24 English
Possible cause
The retaining lugs on the battery
are dirty.
Overload protection.
Battery is discharged.
Jaws are dirty or worn.
Jaw housing not correctly screwed
on.
Spring weak or defective.
Action to be taken
▶ Clean the retaining lug and
re-insert the battery.
▶ Remove metallic residues.
→ page 23
▶ Change the battery and charge
the empty battery.
▶ Clean the jaws or, if applicable,
replace them. → page 23
▶ Screw the jaw housing on
correctly . → page 24
▶ Replace the spring . → page 23
2293235
*2293235*