Inserting The Battery - Hilti Nuron Rt 6-22 Original Bedienungsanleitung

4.3 Table correlating nosepieces and blind rivets to be used
Nosepiece designation
RN 2.4
RN 3.2
RN 4.0
RN 4.8
5 Preparations at the workplace
WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1 Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery. → page 18
5.2

Inserting the battery

WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
5.3 Removing the battery
1. Press the battery release button.
2. Remove the battery from the product.
5.4 Fall arrest
WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti tool tether recommended for your product.
▶ Prior to each use, always check the attachment point of the tool tether for possible damage.
▶ Do not secure a tool tether to the belt hook. Do not use a belt hook to lift the product.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only a combination of the Hilti retaining strap and the Hilti tool tether
#2261970.
▶ Remove the nosepiece holder.
▶ Secure the retaining strap to the installation openings for accessories. Check that it holds securely.
*2293235*
Blind rivet diameter, all commercially available
materials
2.4 mm
3.2 mm
4.0 mm
4.8 mm
5.0 mm (aluminum blind rivets only)
2293235 English 21