TecTake 401166 Bedienungsanleitung Seite 3

Cutting and sanding
A cutting disc is used for cutting metal, plastic, wooden and stone workpieces. A sanding disc
is use for sanding wooden and plastic workpieces. A mandrel is used for mounting a cutting
disc or sanding disc.
•Place the mandrel in the collet nut.
•Loosen the screw on the mandrel.
•Place a cutting disc or sanding disc on the screw.
•Place the screw on the mandrel and tighten it.
Deburring
A grinding disc for deburring is used for removing burrs from metal workpieces. A mandrel is
used for mounting a grinding disc for deburring.
•Place the mandrel in the collet nut.
•Loosen the screw on the mandrel.
•Place a grinding disc for deburring on the screw.
•Place the screw on the mandrel and tighten it.
Drilling
A drill bit is used to drill holes in plastic, wooden and stone workpieces.
•Place a drill bit in the collet nut.
Routing
A router bit is used for grooving and for routing figures in plastic, wooden and metal workpieces.
•Place a router bit in the collet nut
Engraving
An engraving needle is used for engraving figures in metal workpieces.
Place an engraving needle in the collet nut.
Grinding and sanding
A grinding stone is used for grinding metal, plastic, wooden and stone workpieces. A sanding
band is used for sanding wooden and plastic workpieces.
•Place a grinding stone or sanding band with mandrel in the collet nut.
Replacing a sanding band
A sanding band must be replaced when showing signs of wear.
•Remove the old sanding band from the mandrel.
•Place the new sanding band on the mandrel.
. 3 .