Electrical Safety - Tectake 401166 Bedienungsanleitung

ELECTRICAL SAFETY

Always check that the power supply corresponds to the voltage on the rating plate.
DESCRIPTIONS (fig.A)
Your compact hobby tool has been designed for drilling, routing, engraving, polishing,
cutting, grinding and sanding of wood, metal, plastics and stone.
1 On/off switch
2 Speed adjusting wheel
3 Carbon brush holder
4 Collar
5 Collet nut
To mount an accessory, proceed as follows:
•Loosen the collet nut (5).
•Insert the shaft of the accessory into the collet.
•Tighten the collet nut.
•In order to remove the accessory, proceed in reverse order.
Before mounting an accessory, always unplug the tool.
Replacing the collet
•Use the spanner to slacken the collet nut (5).
•Remove the collet nut and the old collet.
•Place the new collet.
•Replace the collet nut.
•Release the spindle lock button.
Always unplug the tool before replacing the collet.
Switching on and off (fig.A)
•To switch the machine on, set on/off switch (1) to '1'.
•To switch the machine off, set on/off switch (1) to '0'.
Adjusting the speed (fig.A)
This machine has been fitted with an adjusting wheel (2) for the maximum speed.
•Choose a low speed for working wood and plastics.
•Also choose a low speed for polishing.
Polishing
A polishing wheel is used for polishing metal and plastic workpieces.
A mandrel is used for mounting a polishing wheel.
•Place the mandrel in the collet nut
•Place a polishing wheel on the screw.
. 2 .