Waterco SUPATUF ECO-V 100 Bedienungsanleitung Seite 6

• English
Ultra Quiet
Supatuf ECO-V 100 operates most economically and with the lowest noise level at its low
speed setting. Its low speed setting significantly reduces the pump's vibration, motor noise
and water turbulence to an ultra low 55.5 decibels (dBA).
Off-Peak Operation
Its low noise levels enable it to be operated at times that are not allowable for conventional
pool pumps. Supatuf ECO-V 100 allows you to take advantage of off-peak electrical tariff
periods, without upsetting your neighbours.
Pump Start Up
The Supatuf ECO-V 100 Variable Speed Pump is designed to operate on speed setting High
when the pump is first turned on. This ensures the pump is properly primed and adequate
flow through the pool's filtration and re-circulation system. The high speed start up will
operate for 3 minutes then switch to the pre-selected speed setting.
During the initial start up period the light on the pre-selected speed setting button will start
flashing. If the pump had a pre-selected speed setting less than 1900 RPM the ECO (Low)
light will be flashing.
Note: The above instructions are only a guide; each pool has individual water pressure and
flow requirements. Supatuf ECO-V 100 Variable Speed Pump has to be sized appropriately
by a pool professional to ensure efficient operation of your pool.
The following charts provide the water flow characteristics of the Supatuf ECO-V 100
Variable Speed Pump at 4, 6, 8 & 10 metre of head loss with minimum pump operating hours.
16
14
12
10
8
6
4
2
0
0.00
Supatuf ECO-V 100
ECO-V
5.00 10.00
Flow (m
MED
LOW
15.00 20.00
/hr)
3
HIGH
25.00