Energy Saving - Waterco SUPATUF ECO-V 100 Bedienungsanleitung

• English
Supatuf ECO-V 100 Variable Speed Pump
Operating Guide
Supatuf ECO-V 100 is equipped with the very latest variable 3 speed permanent magnet
brushless DC motor; Supatuf ECO-V 100 is capable of lowering its energy usage & reducing
its operating noise levels.

Energy Saving

A pool filtration system does not require to be operated at a pump's maximum water flow
rate. In fact, your pool's filtration efficiency improves at lower flow rates. As a pool's filtration
cycle occupies 99% of the run time of a pool pump, you can operate the Supatuf ECO-V 100
on its low (ECO) speed setting for a majority of its running time, leading to 80% savings in
energy.
Supatuf ECO-V 100's Variable 3 speed options
Supatuf ECO-V 100 has 3 factory set speed options ECO (Low), MED & HIGH but with
the additional advantage of fine adjustment in operating speed with 25 RPM increments,
allowing fine tuning of the pump's motor speed to perfectly match the flow requirements
of the swimming pool, maximising energy savings and minimising pump noise. The Supatuf
ECO-V 100 operates most economically and with the lowest noise level using the ECO (Low)
speed option. The Supatuf ECO-V 100 has a variable speed control, ranging from 1000 to
2850 RPM (revolutions per minute). The pump's RPM can be viewed on the control panel
display.
ECO (Low 1900 RPM): Filtration – 99% of the time
Most economical speed for the purpose of operating
the pool's filtration system without any ancillary pool
equipment attached to the re-circulation system.
E.g. suction cleaners.
Medium (2400 RPM): Automatic pool cleaners
This speed will enable the operation additional pool
equipment for pool cleaning functions that require
the use of suction cleaners and low pressure spa jets.
High (2850 RPM): Vacuuming and backwash – 1%
of the time
Power speed selection for use with backwashing
granular media filters (e.g. sand filters), manual pool
vacuuming and operating pool equipment with high
water pressure requirements. E.g. water features and
spa jets.
Stop: This will cancel any variable adjustments made
outside of the above three factory settings.
Power: This will be lit whenever the pump is
operating.