Operation - Husqvarna CG 200 Bedienungsanweisung

Introduction
WARNING:
manual carefully and make sure you
understand the instructions before using the
product.
WARNING:
equipment. See
equipment on page 6 for instructions.
WARNING:
persons are in the working area, otherwise
there is a risk of serious personal injury.
WARNING:
assembled correctly and do not show any
signs of damage.
CAUTION:
requirements in EN61000-3-11 and is
subject for conditional connection to the
mains. It may be connected in consultation
with the supply authority. The equipment
will only be connected to the mains supply
with impedance lower than 0,26 ohm. The
system impedance at the interface point may
be obtained from the supply authority.
If the mains supply has higher system
impedance, short voltage dips may appear
when the equipment is started. This may
influence the operation of other products,
e.g flickering lights.
To start up
CAUTION:
behind the product keeping both hands on
the handles. Maintain a safe distance to the
rotating tool. Make sure that no pipes or
electrical cables are routed in the working
area or in the material to be cut. Do not
leave the product unattended while the
engine is running.
Note:
When the product is engaged it will move
forward uncontrolled due to the activated drum.
1. To start the product, grasp the operator presence
control handle on the steering shaft.
8

Operation

Please read the operator's
Wear personal protective
Personal protective
Make sure no unauthorised
Check that the product is
The equipment fulfills the
The operator position is
2. The motor stops if operator presence control handle
(1) is released.
3. Check regularly that it operates correctly. Do not lock
it in position.
To start the fuel product
1. To start the motor, see the motor manufacturer
manual.
2. Let the motor warm up.
To start the electric product
1. To start the product, push the motor start switch to
ON(I).
130 - 004 - 19.01.2023