Functions - X4-Life Inspector III Bedienungsanleitung

Functions

To switch through the different values in the display press FUNCTION.
LCD­window 1 shows the elapsed time in which the attached device has been
using electricity. First, the two digits on the right show seconds and the ones on
the left show minutes. After 60 minutes, the digits on the right display minutes
and the digits on the left now show hours. After 24 hours the display starts again
at zero and the day display is increased by one.
Note: The measurement may have a deviation of +/­ 2%. Please note
that the time recording will only start at approximately 0,1 watts usage by the
attached device.
Mode 1)
Time/Consumption/Cost
Window 2: Shows the wattage currently used.
Window 3: The total cost of the electricity used (COST).
Mode 2)
Time/Electricity Used/Days
Window 2: The total use in kilowatt hours (KWh).
22