battioni Pagani GARDA EVO Gebrauchs- Und Wartungsanleitungen Seite 136

10
instruction manual
for use and maintenance of the combined groups for the GARDA EVO series
Bombas Pratissoli serie KF
INSTALLATION
The Garda Evo group must be installed rigidly on a planar frame (sized to prevent vibrations and buckling) with a
MAX tilt of 3°. Ensure sufficient space for the circulation of cooling air and to reach the lubrication points (oil levels,
grease nipples, etc.). Leave room to manoeuvre the selection levers. Secure to the frame before the most rigid part
(Garda Evo box).
INSTALLATION HIGH PRESSURE PUMP
The high pressure pump is connected to the gearbox with a support (see Figure above) and the two shafts are
connected by a coupling connection (as shown in Figure 5). The high pressure pump must be secured to the frame
according to the instructions listed in the annexed "Instructions manual" annex. Also for the hydraulic connections,
consult the instructions manual attached.
Junta 5020707020
page 118
11
40
Figure 5 Flexible coupling connection
12 13
40