Step4: Press and hold the
3) Set the power to enter the power saving mode (PSI)
Step1: In the parameters setting interface, click the
PSI parameter.
Step2: Press and hold the
Step3: Click the
• Click the
• Click the
• Press and hold the
adding, the PSI value will increase by 100 each time. When the
released, press and hold it again to repeat the above operation. Note: The
setting parameter cannot exceed the user define, or else; it will return to the
initial value to start the loop.
Step4: Press and hold the
6.2Other Parameters
Users can set the baud rate, output voltage class and output frequency class, etc.
by the remote meter.
Operation:
Step1: In the real-time interface, press
interface.
Step2: Click
or
button to confirm.
button until the PSI value flashes.
or
button to set the PSI parameter.
button to decrease the PSI value by 1.
button to increase the PSI value by 1.
button to increase the PSI value by 10. After ten
button to confirm.
to select the parameter to be configured.
or
for 2s to enter the parameter setting
-17-
button to select the
button is