Part 2- Mechanical Installation - Genmitsu 4040-PRO CNC Benutzerhandbuch

Part 2- Mechanical Installation

Step 1: Preparing the machine for assembly
What you will need
1 Front Module Rear Module (4) Rubber Feet
2 29
1. Go through the parts list above. Ensure you have all the parts included listed in the packing list. If you are missing
anything, or something is damaged, please contact support@sainsmart.com.Before assembly ensure all surfaces and
holes are clear and free of any packing materials.
2. Make sure the front and rear modules are clean.
3. As shown in the picture, stick the rubber feet on the bottom grooves of the left and right ends of the front and rear
modules respectively.
4. Then place the modules on a flat table as shown.
Rear Module
Front Module
(4) Rubber Feet
Bottom Groove
07