Genmitsu 4040-PRO CNC Benutzerhandbuch Seite 10

Step 2: Installing the MDF Spoilboard
What you will need
Allen Wrench Set (4mm)
(2) MDF Board (8) Locating Pin (12) M5*20mm Bolt
9 10 13
7
1. Following the diagram below, align the holes of the MDF spoilboard with the screw holes in the front and rear module,
with the recesses at the top, then loosely screw into place with the (12) M5*20 screws.
(DO NOT TIGHTEN ALL THE WAY, allow for small movement between the MDF spoilboard and the front and rear
module until later.)
2. As shown in the diagram, insert 8 of the locating pins into the corresponding holes on the front and rear modules
respectively. (When inserting the locating pins in the rear module, take care to avoid the wire in its middle square hole to
avoid any damage to the wire)
Cable
Locating Pins
(12) M5*20mm Bolt Locating Pin
Locating Pins
Locating Pins
Locating Pins
08