Beper 90.350 Betriebsanleitung Seite 13

Steam cleaner Use instructions
When using the steam cleaner for the first time it is recommended that the first jet of steam is
directed into a container to get rid of any water which may have collected in the tube (if water is
ejected, this is due to the condensation of steam in the tube). Repeat this operation if the appliance
is not used for more than a few minutes.
When the gun begins to emit steam, always direct the jet downwards.
Fitting accessories
Extension spout:
Insert the accessory by pushing it into the fixed section of the gun and aligning the groove in the
spout with the line on the gun. Then rotate the spout 90 degrees (clockwise) in the direction of the
arrow.
In this way the accessory will remain fixed in place in the locked position.
With this accessory it is possible to obtain fast cleaning in corners normally harbouring the most
stubborn dirt, such as hobs, where thanks to the steam you can remove every trace of grease, na-
turally and without the use of detergents.
Round brush:
This accessory can be fitted to the extension spout and helps to flake off the most stubborn caked-
on dirt, such as around the burners of a hob. Use it to clean sanitary ware, sinks, grills, showers and
baths, eliminating every trace of limescale.
(Separate brushes, for use in different situations, are available from Beper Customer Service).
Inclined nozzle:
This accessory can be attached to the extension spout or the gun nozzle after fitting the hood, or
the extension spout.
Useful for reaching and sanitising difficult areas, such as the dirt which clings to radiators, shutters
and sanitary ware, cleaning them quickly and easily.
Fabric brush:
The fabric brush can be fitted to the gun nozzle. With its handy cap, the brush can be used to get rid
of dust during everyday cleaning of sofas and armchairs, but also in the bedroom on covers, mat-
tresses and pillows, giving you the security of sleeping in a clean bed. The brush can also be used
to refresh fabrics, removing all traces of creasing.
In any case, both the first time the appliance is used and during use, it is recommended that con-
densation is ejected into a container.
WARNING: For delicate fabrics, we recommend checking the manufacturer's instructions first.
Glass brush:
The glass brush can be added to the fabric brush by inserting the hooks on the side of the glass
brush into the slots of the brush and joining the two
Using the glass brush, all glass and mirrors will regain their shine. It is also easy to be used on sho-
wer cubicles, eliminating limescale problems.
Using the extension with the glass brush, it is possible to reach high and out-of-the-way spots such
as high windows and doors.
WARNING: DO NOT USE THE GLASS BRUSH IF THE SURFACE TO BE CLEANED IS VERY
COLD. The difference in temperature could cause the glass to crack.
At times when temperatures are particularly low, preheat the glass by directing steam over the whole
surface to be treated from a distance of about 40 cm.
Extension tubes:
The extension tubes are connected with the coupling between the two tubes. They are used with
the floor brush together with the brush connector. With other accessories they are used with the
extension connector to reach high surfaces.
13