Lamp And Socket Replacement - SCHOTT KL 1500 HAL Bedienungsanleitung

28
3. Lamp and socket
EN
replacement
Safety information
Lamp replacement
Before changing, switch off the light source and disconnect the power plug.
Do not reach into the device immediately after switching it off, as there is a risk
of injury from the fan running after it.
Make sure that the lamp and lamp socket have cooled down before replacing
them.
Open the lamp compartment by pressing down on the recess provided and
simultaneously pulling it as far as it will go.
Remove the lamp, including the base, upwards from the holder. Carefully
remove the lamp from the base and attach a new lamp (please use the lamp
as specified in item 3.1). Then push the lamp into the holder again from above
as far as it will go.
Push the lamp compartment in until it locks into place (you will hear it click into
place). Now you can plug in the power plug and switch on the light source.