Machine Information - VONROC VC509AC Originalbetriebsanleitung

Warning! Avoid contact with the terminals
on the plug when installing (removing) the
plug to (from) the power supply outlet.
Contact will cause a severe electrical shock.
Replacing cables or plugs
Immediately throw away old cables or plugs when
they have been replaced by new ones. It is dange-
rous to insert the plug of a loose cable in the wall
outlet.
Using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The minimum
conductor size is 1.5mm
2
always unwind the reel completely.

2. MACHINE INFORMATION

Intended use
This shampoo vacuum cleaner is intended for
domestic wet and dry vacuuming in, for example,
the house,work room, car or garage. The vacuum
cleaner is equipped with a detergent spraying
function, this can be used to clean stains in carpet
and furniture. This product is not intended for com-
mercial or industrial use.
TECHNICAL SPECIFICATIONS
Model No.
Mains voltage
Mains frequency
Protection class
Power
Cable length
Ingress length
Suction force
Airflow rate
Container capacity
Detergent tank capacity
Filter (dry)
Filter (wet)
WWW.VONROC.COM
. When using a cable reel
VC509AC
220-240V~
50-60 Hz
Class II
1400W
6m
IPX4
≥20kPa
26 L/s
20 L
3.5 L
HEPA filter
Foam filter
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2-10.
1 On/Off switch
2 Top section
3 Container
4 HEPA filter
5 Foam filter (optional)
6 Foam filter
7 Dust bag
8 Carpet cleaning nozzle
9 Furniture cleaning nozzle
10 Wet & dry floor brush
11 Crevice nozzle
12 Suction tube
13 Handle / detergent spray gun
14 Flexible hose
15 Carrying handle
16 Detergent tank
17 Locking clamp
18 Castor wheel
19 Rear wheel
20 Detergent tube
21 Screw
22 Filter cage
23 Water separator
24 Shut-off float
25 Spray gun trigger
26 Airflow adjustment slider
27 Blower port
28 Fiilter cleaning button
29 Detergent tube
30 Detergent inlet
31 Detergent outlet
3. ASSEMBLY
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
Attaching the wheels (Fig. B)
1. Press the castor wheels (18) into the base of
the machine
2. Use the supplied screws (21) to attach the rear
wheels (19) to the base
Attaching the detergent tank (Fig. C-1, C-2, C-3)
1. Fit the detergent tank (16) on the base of the
machine
EN
13