Machine Information; Technical Specifications - VONROC VC505AC Bersetzung Der Originalbetriebsanleitung

EN
SAFETY WARNINGS SPECIFIC FOR BLOWING
a) Direct air discharge at work area only. Never at
people or animals.
b) Risk of flying objects. Keep bystanders away
from the work area.
c) Always wear safety goggles before using the
blowing function.
Electrical safety
When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions.
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate label.
Class II machine - Double insulation – You
don't need any earthed plug.
If operating a power tool in a damp location is
unavoidable, use a residual current device (RCD)
protected supply. Use of an RCD reduces the risk of
electric shock.

2. MACHINE INFORMATION

Intended use
The vacuum cleaner is intended for domestic cold
ash vacuuming, for example, cleaning a fireplace,
barbeque or other ash residue. The vacuum cleaner
is equipped with a blowing function. It can be used
to blow dust and debris out of garages or of patios
and driveways. The device is not suitable for com­
mercial or industrial use.

TECHNICAL SPECIFICATIONS

Model No.
Mains voltage
Mains frequency
Power input
Cable length
Protection category
Suction force
Container capacity
Filter
6
VC505AC
220­240V~
50­60 Hz
1600W
3m
Class II
20 kPA, 1.6 m /min
3
approx. 20 L
HEPA
Hose system
Hose Length
Recommended Filter
Weight (incl. all accessories)
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2­3.
1. On/Off switch
2. Carrying handle
3. Vacuum port
4. Blowing port
5. Metal locking clamp
6. Nozzles storage
7. Container
8. Top section
9. Hose
10. Aluminium tube
11. HEPA Filter
12. Filter holder
3. ASSEMBLY
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
• Slide the HEPA filter (11) over the filter holder
(12) as shown in Fig. B.
Clean the HEPA filter (11) regularly and
after every heavy use to maintain the
suction power.
• Place the top section (8) on the container (7) as
shown in Fig. C1.
• Secure the metal locking clamps of the contain­
er to the top section as show in Fig. C2.
• Close the metal locking clamps by pushing
them downwards.
• Connect the suction hose (9).
­ For vacuuming (Fig. D): Connect the suction
hose (9) to the vacuum port (3).
­ For blowing (Fig. E): Connect the suction
hose (9) to the blowing port (4).
• Connect the aluminum tube (10) to the hose (9).
35mm
1.2m
VC808AC
approx. 3.3 kg
WWW.VONROC.COM